How To Use Your Vacuum Cleaner; Power Switch - Eureka 95 Owner's Manual

How to assemble your vacuum cleaner
O
AA
Fig. 5
Fig. 6
Fig. 7
Fig. 8
6
Eureka Customer Service HELPLINE 1-800-282-2886
Charge the Batteries
Note: Charge the batteries for 14-16 hours before
initial use. A cleaner may lose charge in
shipment. The charger plug will become
warm, however this is not a cause for
concern.
Note: If the batteries are completely void of
charge, the charging light may not shine
until there is sufficient charge in the
batteries to provide power.
Step 1: Turn the nozzle
cleaner onto the bracket
remove the battery from the cleaner and
place battery in charging stand.
Step 2: Charge light
after the charger is connected with the
power supply. Charge light
charging. It will stop blinking when charge is
complete. It is all right to leave the cleaner
on constant charge so it is always ready to
use. Unplug only if it will not be in use for
several weeks at a time.
Note: You can charge a battery in the unit and an
extra battery (optional) at the same time.
How to use

Power Switch

Note: On initial use, the clear plastic shipping
switch lock must be removed to activate
the switch. Pull on tab to remove.
Step 1: Push the power switch
push up to turn off (Fig. 6).
Select type of cleaning. Carpet cleaning
starts the brush roll turning. Bare floor
cleaning stops the brush roll (Fig. 6).
Step 2: To use on bare floors or area rugs, make
sure that handle
cleaner body (Fig. 7).
Step 3: To use as a handvac remove handle
releasing the lock button
down and lower the
O
(Fig. 5) or
I
shows a steady glow
J
blinks while
K
down to turn on;
N
is attached to the
G
(Fig. 8).
M
(continued)
by
G