Fujitsu XG2000CR Hardware Manual page 9

Laser safety
The XG2000CR can be installed with a class 1 laser module (XFP module), and can emit
invisible laser light. Do not look into the 10 Gigabit Ethernet port openings. The following
warning applies to the XG2000CR's laser:
• The XG2000CR can be installed with XFP modules, which are laser devices.
In the USA, these XFP modules are certified as Class 1 laser products that conform to the
requirements of the Department of Health and Human Services (DHHS) regulation 21 CFR
Subchapter J, and this certification is indicated by a label attached to each XFP module.
Outside the USA, these XFP modules are certified as Class 1 laser products that conform
to the requirements given in IEC60825-1 (2007) and EN60825 (2007).
• Even when cables are not connected, invisible laser light may be still emitted from the
port openings. To avoid this laser light, never peer into the port openings.
*XFP module which install in XG2000CR must be selected from our approved vendor list
(Please contact your vendor's representative for the XFP module approved vendor list).
Power Cord Requirements
Use the power cord attached for this product.
The power cord attached for this product can not be used on any other products.
Power cord for use in other countries must meet the requirements of the country where you
use this product.
Attached power cord is for exclusive use of USA or CANADA.
If you use this product in other country, contact your vendor's representative.
WARNING
Do not use the power cords attached to this product for other products, as there is a
risk of electric shock, fire, and/or damage.
Connecting the power cords
After connecting the peripheral units, connect the XG2000CR power cords.
WARNING
• Do not touch the power plug with wet hands, as there is a risk of electric shock.
• Do not damage or remodel the power cords, as this may cause electric shock or
fire. Placing a heavy object on, pulling, excessively bending, twisting, or overheat-
ing a power cord can damage it, and may cause electric shock or fire.
• Do not use the XG2000CR with a damaged power cord, a damaged power plug,
and/or a loose socket. Continued use under these conditions may cause a fire.
• If the power plug pins or socket holes are dusty, clean with a dry cloth. Continued
use with a dirty power plug or socket may cause electric shock or fire.
For Safe Use of the XG2000CR
7