Njoy Helios PRO Series User Manual page 7

B. Tower instalation
First fix the holders
to fit the UPS.
Step 3.
UPS input connection: Plug the UPS into a two-
pole, three-wire, grounded receptacle only.
Avoid using extension cords.
Step 4.
UPS output connection: For socket-type
outputs there
programmable outlets and general outlets.
Please connect non-critical devices to the
programmable outlets and critical devices to
the general outlets. During power failure, you
may extend the backup time to critical devices
by setting shorter backup time for non critical
devices.
12
Then put the UPS in
place.
two kinds of output:
CAUTION
Do NOT plug
LASER PRINTERS
into any of the
outlets.
Step 5. Communication connection
Communication port:
USB Port RS-232 Port
To allow for unattended UPS shutdown/start-up and
status monitoring, connect the communication cable
one end to the USB/RS-232 port and the other to the
communication port of your PC. With the monitoring
software installed, you can schedule UPS shutdown/
start-up and monitor UPS status through PC. The UPS is
equipped with slot perfect for either SNMP or AS400
card. When installing either SNMP or AS400 card in the
UPS, it will provide advanced communication and
monitoring options.
PS: USB port and RS-232 port can't work at the same
time.
Do NOT plug any
SURGE STRIPS
into any of the
outlets.
Intelligent slot
13