Pepperl+Fuchs LAL-SRW series Manual page 26

WARNING DEVICE LAL-SRW
Commissioning
Switches
EN
DIP 1 NVF sensor
(NVF-104/34-PF)
DIP 2 KVF sensor (KVF-104-PF)
or SLU sensor (SLU-103-**)
DIP 3 Acoustic alarm
DIP 4 Relay setting
DIP 5
DIP 4 Relay setting
DIP 5
DIP 4 Relay setting
DIP 5
DIP 4 Relay setting
DIP 5
DIP 6 Repeat alarm setting in 24
hours
DIP 7 Reset key (ALARM RESET
activation)
DIP 8 Not in use
24 - EN
The following table contains a list of possible configuration settings.
Description
ON connected
OFF not connected
ON connected
OFF not connected
ON Acoustic alarm on.
OFF Acoustic alarm off.
ON Relays 1 and 2 switch, irrespective of the alarm states. If
the alarm event is no longer present, relay 1
automatically switches back AND relay 2 remains
unchanged until the alarm is cleared by pressing the
ON
"ALARM RESET" button. It shows that an alarm
occurred.
ON Relays 1 and 2 switch, irrespective of the alarm states.
After 3 minutes, relay 2 switches again (even if an alarm
status is present). Relay 1 and/or relay 2 are reset when
the sensor no longer has an alarm status. Pressing the
OFF
"ALARM RESET" button switches the relays again.
OFF In the case of active alarm status, relay 1 switches to
NVF sensor and relay 2 switches to KVF or SLU
sensor. Relay 1 and/or relay 2 are reset when the
ON
sensor no longer has an alarm status. Pressing the
"ALARM RESET" button switches the relays again.
OFF Relays 1 and 2 switch irrespective of the alarm states
and with which sensor. Relay 1 and relay 2 are reset
when the sensor no longer has an alarm status.
OFF
Pressing the "ALARM RESET" button switches the
relays again.
ON Repeat alarm on. This also applies to the function of
relays 1 and 2.
OFF Repeat alarm off.
ON "ALARM RESET" button is activated. The acoustic
alarm and the alarm relay can be reset.
OFF "ALARM RESET" button is deactivated. The acoustic
alarm and the alarm relay cannot be reset.