Inhep Digital Security IDS816 Installer's Manual page 11

IDS816 INSTALLER MANUAL
Note: Once the reset switch has been disabled in programming it
will not be possible to default the panel using the reset
switch. The panel can only be defaulted if a valid installer
code is entered and a value of [0] is entered into location 0.
1 . 3 D e a f u t l
To default the I.D of a keypad(s):
1. Remove power to the keypad and the restore power while holding
down the [1] and [3] keys simultaneously for three seconds.
2. All the keypad LEDs will flash ON and OFF together. Wait for five
seconds and then press the [#] hash key to allocate a new I.D
to the defaulted keypad. Keypad I.Ds are allocated incrementally.
3. The I.D of any keypad can be interograted by viewing the data in
location 446.
1 . 4 E v e t n L
A comprehensive log of the thousand most recent events are retained
in the non-volatile EEPROM. The log may be retrieved using the up/
download software. Alternately it can be viewed using an LCD keypad.
1 . 5 D o w n o l
A download code in conjunction with the installer code is used for
download access. The default download code is 9999. Using the
downloading software it is possible to program a location that will
either allow or disallow defaulting of the download code. This location
is only accessible using the download software. If defaulted the
download code will revert back to 9999. A value of [1] [0] programmed
into this location will prevent the download code from being defaulted
when performing a hardware reset.
IDS816 INSTALLER MANUAL NO. 700-283-02B ISSUED NOV 2004 VER 2.00
n i g K e y p a d s
o g
a d C o d e
11