Panasonic KX-TDA15 Installation Manual page 123

• For safety reasons, do not stretch, bend, or pinch the AC cord and the DC cable of
the AC adaptor.
5.
Press the Reset Button with a pointed tool. (The RUN indicator will flash.)
6.
While the RUN indicator is flashing (within about 10 s), return the System Initialise Switch
to the "NORMAL" position. Depending on the configuration, initialisation takes about 1 min
to 3 min. If successfully executed, the RUN indicator will stop flashing and be kept lit.
All data will be cleared, and the Hybrid IP-PBX as well as all optional service cards (except for
the IP-GW4 card) will be initialised to the default values. The DPTs should show the time as
01:00.
The data of the IP-GW4 card will not be initialised.
Note
Use the same types of AC adaptor and AC cord that are supplied with the Hybrid IP-PBX
only.
LED Indications
Indication
RUN
ALARM
Confirming the Trunk Connection
After initialisation, programme the Hybrid IP-PBX and establish trunk connection, and then use
a PT to confirm it.
To confirm, dial [ ] [3] [7] + trunk number (3 digits) or press S-CO button. You will hear a dial
tone if the trunk is available and connected.
Turning off the Hybrid IP-PBX
For safety reasons, make sure to turn off the power switch before unplugging the Hybrid IP-
PBX. To unplug, follow the reverse steps to plug it in.
Colour Description
Green PBX status indication
• OFF: Power Off (includes normal reset)
• ON: Power On and running (on-line)
• Flashing (60 times per minute): Starting up
• Flashing (120 times per minute): Starting up or resetting with:
• the System Initialise Switch in "SYSTEM INITIALIZE"
position
• the SD Memory Card not inserted
Red Alarm indication
• OFF: Normal
• ON: Alarm (CPU stop, alarm for each card)
• Flashing: Alarm (MPR file error in restarting)
2.10 Starting the Hybrid IP-PBX
Installation Manual 123