Table of Contents
Advertisement
NOTE:
Before using the charging device, always
make sure that it is appropriate for the
installed battery, with constant voltage
(below 14.8 Volts) and low amperage
(maximum 15 Amps).
Recharge the battery in a well ventilated
environment.
Before using any devices to charge or to
maintain the charge of the battery, carefully
follow the instructions provided with the
device in order to properly and safely
connect it to the vehicle battery.
You can recharge the battery without discon-
necting the wires of the vehicle's electrical
system.
To reach the battery, remove the load floor
inside the liftgate.
260
Load Floor
Locate the battery access panel under the
load floor.
Battery Access Panel
Remove the protective cover and connect
the positive cable terminal of the charger
(usually red) to the positive terminal (+) of
the battery.
Connect the negative terminal of the
charger (usually black) to nut next to the
negative terminal (-) of the battery.
Battery
1 — Protective Cover
2 — Negative Post (Nut)
The vehicle is equipped with an Intelligent
Battery Sensor (IBS), which is able to measure
the charge and discharge voltage and calcu-
late the charge level and the general condition
of the battery. The sensor is placed next to the
negative terminal (-) of the battery.
Advertisement
Table of Contents
