Bulb Replacement; General Instructions - Alfa Romeo STELVIO 2020 Owner's Manual

WARNING! (Continued)
Ignoring the LED on the SOS-Emergency

Call button could mean you will not have
emergency call services if needed. If the
LED on SOS-Emergency Call button is illu-
minated red, contact the Service Network
to have the emergency call system
checked immediately.
If anyone in the vehicle could be in danger

(e.g., fire or smoke is visible, dangerous
road conditions or location), do not wait
for voice contact from an emergency
service operator. All occupants should exit
the vehicle immediately and move to a
safe location.
Failure to perform scheduled mainte-

nance and regularly inspect your vehicle
may result in vehicle damage, accident or
injury.
224
Frequently Asked Questions:
What happens if I accidentally push the SOS -
Emergency Call Button? You have 10 seconds
after pushing the emergency button to cancel
the call. To cancel the call, push the button
again.
What type of information is sent when I make
an SOS - Emergency Call from my vehicle?
Certain vehicle information, such as the VIN, is
transmitted along with last known GPS loca-
tion. Also note that emergency service opera-
tors may record conversations and sounds
within your vehicle once a connection is made,
and that by using the service you consent to
having this information shared.
When can I use the SOS - Emergency
Call button? You can ONLY use the
SOS - Emergency Call button to
make a call if you or someone else
needs emergency assistance.

BULB REPLACEMENT

General Instructions

Before replacing a bulb, check the contacts

for oxidation.
Replace blown bulbs with others of the

same type and power.
After replacing a headlight bulb, always

check its alignment.
When a light is not working, check that the

corresponding fuse is
changing the bulb. For the location of fuses,
refer to "Fuses" in this chapter.
NOTE:
In some particular climate conditions, such as
low temperature, humidity, or after washing
the vehicle, a thin condensation layer may
form on the internal surfaces of the front and
rear headlights. This condensation will disap-
pear after switching on the headlights.
intact before