Table of Contents
Advertisement
TM
OptiView
Getting Started Guide
Management configuration mode user commands:
"ipaddr
A.B.C.D
E.F.G.H"
"ipaddr dhcp"
"iprouter
A.B.C.D"
"apply"
"exit"
"show (user
command)"
"show all"
22
Statically assign the IP address (A.B.C.D) and subnet mask
(E.F.G.H) of the Management port. Address and subnet mask
are entered in decimal dot notation.
Enable the automatic configuration of the Management port IP
parameters via a DHCP server.
Statically assign the IP address (A.B.C.D) of the default router
on the Management port. Address is entered in decimal dot
notation.
Applies the changes (if any) made to the Management port
configuration. Management port configuration changes do not
take effect until this command is entered.
Exits the Management configuration mode. Exiting will
discard any Management port configuration changes unless
'apply' is entered.
Displays the current value of an individual setup parameter of
interest within the Management configuration mode.
Displays the current values of all setup parameters within the
Management configuration mode.
Advertisement
Table of Contents
