Page 1
INSTALLATION AND USER’S MANUAL CU - 230V - HP Control unit comunello.com ISTRUZIONI D’USO E DI INSTALLAZIONE INSTALLATIONS-UND GEBRAUCHSANLEITUNG INSTRUCIONS D’UTILISATION ET D’INSTALLATION INSTRUCCIONES DE USO Y DE INSTALACION ИНСТРУКЦИЯ ПО МОНТАЖУ Cod. 91300176 Rev. 01 - 25.03.15...
Page 2
REMOTE PRG LEV MENÙ LEVEL 2 FLASHES EXTENDED MENÙ 3 SOFT STOP SOFT START RELEASE STROKE SLAM LOCK ELS / PED CMD PAUSE FLASHING PREFLASH / COURTESY LIGHT LEV MENU LEVEL 3 FLASHES COMUNELLO ®Copyright 2014 - All right reserved...
Page 3
4A , 5A Photocell TX 2x0,5mm2 2x1,0mm2 FROR CEI 20-22 CEI EN 50267-2-1 4B , 5B Photocell RX 4x0,5mm2 4x1,0mm2 Key selector 3x0,5mm2 3x1,0mm2 Limit switch 3x0,5mm2 3x1,0mm2 Encoder 3x0,5mm2 3x1,0mm2 Antenna RG58 max 20m COMUNELLO ®Copyright 2014 - All right reserved...
Page 4
MOTORE n1 MOTOR n1 230V 50HZ MOTORE n2 LAMPEGGIANTE MOTORE n2 FLASHING 230V 50HZ 230V 500W FINECORSA CHIUSURA (N.C.) MOTORE n2 END CLOSE (N.C.) MOTOR n2 ENCODER MOTORE n2 MOTOR n2 FINECORSA APERTURA (N.C.) MOTORE n2 END OPEN (N.C.) MOTOR n2 LINEA POWER SUPPLY ENCODER...
Page 5
(NO-ELECTRICITY SUPPLIED) BLACK ON OPEN M2 NOT MOTOR CONSID. FORT opens to LEFT Innner side view M2 NOT CONSID. MOT 1 FORT opens to RIGHT Innner side view M2 NOT CONSID. MOT 1 COMUNELLO ®Copyright 2014 - All right reserved...
Page 6
SALIENT MOTOR 1 OUTPUT: MOTOR 2 OUTPUT: BLACK ON NOT USED CLOSED COMMON (NO-ELECTRICITY SUPPLIED) BROWN ON OPEN M2 NOT MOTOR CONSID. SALIENT: DO NOT CHANGE the configuration! Opens to left, closes to right (left profile view, as in the image).
Page 7
• DELAY OF THE MOTOR n.2 DELAY MOTORS MOT.2 • DELAY OF THE MOTOR n.1 DELAY MOTORS MOT.1 Configuration: OPEN with OP1 OPEN with OP2 COMMON with CM1 COMMON with CM2 CLOSED with CL1 CLOSED with CL2 COMUNELLO ®Copyright 2014 - All right reserved...
Page 8
RAM - connection diagram of the motors • DELAY OF THE MOTOR n.2 DELAY MOTORS MOT.2 • DELAY OF THE MOTOR n.1 DELAY MOTORS MOT.1 Configuration: OPEN with OP1 OPEN with OP2 COMMON with CM1 COMMON with CM2 CLOSED with CL1 CLOSED with CL2...
Page 9
[ALREADY CONNECTED] OPEN with OP2 BLACK with OP1 COMMON with CM2 BLUE on CM1 CLOSED on CL2 Blue BROWN on CL1 Brown Black 2nCH 2nCH FOT+ L24V S8K2 PPED ELS+ ELS- +LED ANT- ANT+ COMUNELLO ®Copyright 2014 - All right reserved...
Page 10
CONDOR - [2/2] • DELAY OF THE MOTOR n.1 DELAY MOTORS MOT.1 MOT.1 • DELAY OF THE MOTOR n.2 DELAY MOTORS MOT.2 MOT.1 Configuration - MASTER ON THE RIGHT, SLAVE ON THE LEFT MOTOR n.2 WITHOUT CONTROL UNIT (on the left) MOTOR n.1 WITH CONTROL UNIT (on the right) OPEN with OP2 BLACK with OP1...
Page 11
Configuration - MOTOR n.1 ON THE LEFT, MOTOR n.2 ON THE RIGHT MOTOR n.1 (on the left) MOTOR n.2 (on the right) BLACK with OP1 BLACK with OP2 BLUE on CM1 BLUE on CM2 BROWN on CL1 BROWN on CL2 COMUNELLO ®Copyright 2014 - All right reserved...
Page 12
Configuration - MOTOR n.1 ON THE LEFT, MOTOR n.2 ON THE RIGHT MOTOR n.1 (on the left) MOTOR n.2 (on the right) OPEN with OP1 OPEN with OP2 COMMON on CM1 COMMON on CM2 CLOSED on CL1 CLOSED on CL2 COMUNELLO ®Copyright 2014 - All right reserved...
Page 13
INSTALLATION AND USER’S MANUAL CU - 230V - HP EC DECLARATION OF COMFORMITY: The undersigned Mr. Luca Comunello, representing the following manufacturer, Fratelli COMUNELLO Spa Via Cassola 64, 36027 Rosà (VI) – Italy DECLARES that the equipment described below: Electronic control unit...
Page 14
(re-programming, Take all the measures required to ensure the repair or modification of the installation); contact installation procedures do not affect the IP technical service. rating. COMUNELLO ®Copyright 2014 - All right reserved...
Tripping during opening causes momentary stopping of the gate; once the passage is free, the control unit resumes the opening movement. TRANSFORMER CONNECTIONS Tripping during closing causes reversal of the direction of movement. CN5 (1st): 1: 230 V~ Transformer Primary Winding Input. COMUNELLO ®Copyright 2014 - All right reserved...
Page 16
10 seconds shown by blinking of the LED; when is anyway possible to disable the deceleration stage (see Extended this interval elapses, the control unit returns to the original state. COMUNELLO ®Copyright 2014 - All right reserved...
Page 17
Operator 2 will perform closing until reaching rolling code remotes. the limit switch or end stop, thereafter the Operator 1 movement will COMUNELLO ®Copyright 2014 - All right reserved...
Page 18
Extended Menu 1 (alternate blinking 1 0 1 0 1 0 of operation will be completed. menu LED LEV) and then use the SEL key to select blinking LED L3 and press the SET key; LED L3 becomes steady on and the operation COMUNELLO ®Copyright 2014 - All right reserved...
Page 19
LED L6 and press the SET key; LED L6 becomes steady on allow correct execution of the opening cycle. If you wish to enable the COMUNELLO ®Copyright 2014 - All right reserved...
Page 20
If you wish to enable the Slam Lock function at the power set via the “FORCE” Trimmer, repeat the operation described above, pressing the Fratelli Comunello SpA provides a warranty for 24 months for the correct SEL key twice (LED L4 will blink rapidly) rather than once. Repeat the functioning of the actuators from the date of manufacture, provided procedure if you wish to restore the initial configuration.
Page 21
NOTES COMUNELLO ®Copyright 2014 - All right reserved...
Need help?
Do you have a question about the CU-230V-HP and is the answer not in the manual?
Questions and answers