Page 1
INSTALLATION AND USER’S MANUAL QUAD - 24V - 2M Control unit comunello.com ISTRUZIONI D’USO E DI INSTALLAZIONE INSTRUCIONS D’UTILISATION ET D’INSTALLATION INSTALLATIONS-UND GEBRAUCHSANLEITUNG INSTRUCCIONES DE USO Y DE INSTALACION ИНСТРУКЦИЯ ПО МОНТАЖУ Cod. 91300169 - Rev. 01 - 30.04.15...
Page 2
LED 1 + LED 2 +LED 3 +LED 4 +LED 5 + LED 6 LED 1 + LED 2 +LED 3 +LED 4 +LED 5 + LED 6 + LED 7 Menù 3 FLASHES COMUNELLO ®Copyright 2014 - All right reserved...
Page 3
FIG. 1 FIG. 2 FIG. 3 FIG. 3B MAX 20mm COMUNELLO ®Copyright 2014 - All right reserved...
Page 4
2x4,0mm2 Flashing light 2x0,5mm2 2x1,0mm2 FG7 CEI 20-22 CEI EN 50267-2-1 4A , 5A Photocell TX 2x0,5mm2 2x1,0mm2 4B , 5B Photocell RX 4x0,5mm2 4x1,0mm2 Key selector 3x0,5mm2 3x1,0mm2 Antenna RG58 max 20m COMUNELLO ®Copyright 2014 - All right reserved...
Page 5
PULSANTE APRI-CHIUDI (N.O.) PUSCH BUTTON (N.O.) ANT- ANTENNA ANT+ 1 ST PULSANTE PEDONALE (N.O.) PEDESTRIAN PUSH BUTTON (N.O.) LINEA POWER SUPPLY 230V 50Hz (*) Contatto pulito (M.O.) max 3A per sezionare l’alimentazione esterna dell’elettroserratura COMUNELLO ®Copyright 2014 - All right reserved...
Page 6
• DELAY LED OFF = DELAY OF THE MOTOR n.2 • DELAY LED ON = DELAY OF THE MOTOR n.1 Configuration: 24V with M1+ 24V with M2+ 0V with M1- 0V with M2- 2N D COMUNELLO ®Copyright 2014 - All right reserved...
Page 7
• DELAY LED OFF = DELAY OF THE MOTOR n.2 • DELAY LED ON = DELAY OF THE MOTOR n.1 Configuration: 24V with M1+ 24V with M2+ 0V with M1 - 0V with M2- 2N D COMUNELLO ®Copyright 2014 - All right reserved...
Page 8
MOTOR n.1 WITH CONTROL UNIT (on the left) MOTOR n.2 WITHOUT CONTROL UNIT (on the right) RED with M1+ 24V with M2- BLACK with M1- 0V with M2+ Black 2 ND ELS+ FOT+ ANT+ 1 ST COMUNELLO ®Copyright 2014 - All right reserved...
Page 9
MOTOR n.1 WITH CONTROL UNIT (on the right) 24V with M2+ [INVERT THE WIRES IN CONTROL UNIT] 0V with M2 - RED with M1- BLACK with M1+ Black 2 ND ELS+ FOT+ ANT+ 1 ST COMUNELLO ®Copyright 2014 - All right reserved...
Page 10
Configuration - MASTER ON THE RIGHT, SLAVE ON THE LEFT MOTOR n.1 (on the left) MOTOR n.2 (on the right) RED with M1+ [INVERTED CONFIG. COMPARED TO MOTOR n.1] BLACK with M1- RED with M2- BLACK with M2+ 2N D COMUNELLO ®Copyright 2014 - All right reserved...
Page 11
Configuration - MASTER ON THE RIGHT, SLAVE ON THE LEFT MOTOR n.1 (on the left) MOTOR n.2 (on the right) 24V with M1+ 24V with M2- 0V with M1- 0V with M2+ 2N D COMUNELLO ®Copyright 2014 - All right reserved...
Page 12
INSTALLATION AND USER’S MANUAL QUAD - 24V - 2M EC DECLARATION OF COMFORMITY: The undersigned Mr. Luca Comunello, representing the following manufacturer, Fratelli COMUNELLO Spa Via Cassola 64, 36027 Rosà (VI) – Italy DECLARES that the equipment described below: Description:...
• Check that the product in the pack is intact and in good condition. compliance with the prescriptions of EN 12453, • Check that the place of installation is suitable and in compliance with the point 5.2.7. minimum dimensions shown in FIG. 1. COMUNELLO ®Copyright 2014 - All right reserved...
7Ah, which will allow the any additional commands. execution of several complete opening and closing cycles at reduced speed The selection of this type of operation is described in Pause time programming mode (PAUSE TIME). COMUNELLO ®Copyright 2014 - All right reserved...
SET for > 5 s. After this interval the LED will switch off for 2 seconds FOTOTEST and the procedure is completed. If all CODE and PEDESTRIAN codes are deleted, the LED will remain off. PEDESTRIAN TIME COMUNELLO ®Copyright 2014 - All right reserved...
Page 16
2 seconds of operation. Repeat the procedure if you wish to restore the Release Stroke function at the power set with the “FORCE” trimmer, repeat previous configuration. the procedure described above, Note: when the Soft Start function is enabled, the control unit automatically COMUNELLO ®Copyright 2014 - All right reserved...
7. ALWAYS CLOSE FUNCTION: Fratelli Comunello SpA provides a warranty for 24 months for the correct The control unit provides the facility to set “Always Close” operation: this functioning of the actuators from the date of manufacture, provided that the...
Need help?
Do you have a question about the QUAD - 24V - 2M and is the answer not in the manual?
Questions and answers