Table of Contents
Advertisement
Fitting supplied wall spacers
The wall spacers supplied must be
used in order to achieve declared en-
ergy consumption values and to pre-
vent the build-up of condensation at
high ambient temperatures. The appli-
ance depth is increased by approx.
15 mm with the wall spacers fitted. If
the wall spacers are not used, the
functionality of the appliance is not af-
fected. Energy consumption is only
slightly increased with less distance
between the appliance and the wall.
Fit the wall spacers onto the back of
the refrigeration appliance on the bot-
tom left and right.
Limiting the opening angle of the ap-
pliance door
The door hinges are set ex works to en-
able the door to be opened up to 115°.
If the appliance door hits an adjacent
wall when opened, for example, the
opening angle can be limited to approx.
90°:
The door opening angle limiter should
be fitted before the refrigeration appli-
ance is installed.
Fitting the door opening angle limiter
Switch off at the wall and remove the
plug from the socket, or disconnect
the mains fuse.
– Removing the soft-close mechan-
ism
Open the appliance door.
Push off right outer cover .
Installation
81
Advertisement
Table of Contents
