Table of Contents
Advertisement
The optimum temperature and air quality
Touch
OK
immediately after setting
the temperature to confirm your entry.
Or wait approximately 8 seconds
after the last touch of a sensor. The
temperature will then be automatically
adopted.
Tip: The newly set temperature can also
be confirmed and adopted by closing
the appliance door.
The temperature display will then
change to the current temperature in
the wine conditioning unit.
Temperature range
– The temperature in the wine condi-
tioning zones can be adjusted
from 5 °C to 20 °C.
– The temperature in the freezer sec-
tion can be adjusted from -16 °C to
-26 °C.
Tip: If you have adjusted the temperat-
ure, wait for approx. 6 hours if the ap-
pliance is not very full and for approx.
24 hours if the appliance is full before
checking the temperature display, as it
will take this long for the appliance to
give an accurate reading.
If, after this time, the temperature is
still too high or too low, you will need
to adjust it again.
30
Temperature display
In normal operation the temperature
display shows the current temperat-
ure in the middle of the wine condi-
tioning zone, and the current temper-
ature in the warmest part of the
freezer section.
If the temperature in the freezer section
is not within the normal temperature
display range, dashes will flash in the
display.
Depending on the ambient temperature
and the temperature setting, it can take
the appliance a few hours to reach the
temperature required and for this tem-
perature to then be shown as a con-
stant temperature in the display.
If the temperature in the freezer
section remains above -18 °C for a
long time, check that the frozen food
has not started to defrost.
If it has, check that the food is safe
to use and if it is, then use it as soon
as possible or cook it before freezing
it again.
Advertisement
Table of Contents
