Table of Contents
Advertisement
Installation surface
A concrete floor is the most suitable in-
stallation surface, being far less prone
to vibration during the spin cycle than
wooden floorboards or a carpeted sur-
face.
The machine must be level and se-
curely positioned.
To avoid vibrations during spinning,
the machine should not be installed
on soft floor coverings.
If installing on a wooden joist floor:
Install the machine on a plywood
base (at least 70 x 60 x 3 cm). The
base should span several joists and
be bolted to the joists and not only to
the floorboards.
Tip: If possible, install the machine in a
corner of the room. This is usually the
most stable part of the floor.
Removing the transit bars
Remove the left and right caps.
1. Pull on the secured cap stoppers
2. and use a screwdriver to release the
catches at the top and bottom.
Using the spanner supplied, turn the
left-hand transit bar 90°.
Installation
51
Hide quick links:
Advertisement
Table of Contents
