Advertisement
To Install the New CD-ROM Drive Cable
For this procedure, refer to
1
2, 3
4, 5
FIGURE 8
1. Clean the inside surface of the chassis between the CD-ROM drive and the power
supply.
2. Plug the end of the new cable labeled "DRIVE" into the CD-ROM drive.
3. Peel the adhesive backing from the dual lock fasteners.
4. Align the left edge of the ferrite filter with the CD-ROM drive cable connector.
5. Press the sticky side of the dual lock fasteners to where you cleaned the chassis.
Press firmly.
FIGURE 8
Installing the New CD-ROM Drive Cable
.
6
Sun Ultra 10 EMI Retrofit Guide
9
Advertisement
