Jaco EVO User Manual page 28

 If there is still no power to the computer & LCD, contact JACO for replacement
authorization or additional troubleshooting direction.
The computer/LCD or laptop is integrated and working without issue however
the Mobile Cart battery status LEDs are not working in both the front AND back
of cart.
 Remove and reinstall the same Power Blade Battery Packs that are currently in the
Cart, if the LED's still do not light, replace the batteries with 2 fully charged batteries.
 If the status LED's, are still not showing, you will need to reset the controller unit.
To reset, insert a paper
clip into the reset port at
the back of the Cart as
shown. Once paper clip is
inserted and the internal
button depressed, the
unit will beep signifying a
system reset. Remove
the paper clip and watch
for the status LED's to
function.
 If the status LEDs are still not functioning, contact JACO for replacement
authorization or additional troubleshooting direction.
The Mobile Cart front battery status LEDs are not working however the rear
status LEDs are working correctly.
 Remove and reinstall the same Power Blade Battery Packs that are currently in the
Cart, if the LED's still do not light, replace the batteries with 2 fully charged batteries.
 If the front LEDs are still not functioning, check that the input/output cable
connection, as shown in Section 6 of this guide, are connected correctly and seated
properly.
 If the front status LEDs are still not functioning, contact JACO for replacement
authorization or additional troubleshooting direction.
27