Set-Up And Calibration - Jaco EVO User Manual

Carts and include two different power system options. The L250 is a one battery pack power
system and the L500 integrates two battery packs for extended run time. Both options are
Lithium Iron Phosphate, also known as LiFePO4 or LFP.
When ordered with the JACO One EVO Mobile Cart, the LiFePO4 Battery systems are
shipped fully integrated but will need to be calibrated for proper power level status
reporting, see the following pages for detailed instructions.
The JACO Power systems include two separate components, connected by a DC cable that
runs through the Cart Post. This cable connects the LiFePO4 battery packs, located in the
Cart Base, to the Inverter/Charger assembly which is located within the Cart Top Assembly.
Inverter/Charger assembly input & output connections are shown below. Make sure that
you only use JACO approved cables and connections with the JACO Battery System
Left side view
AC Input
1.
On/Off AC Outlet Switch
2.
AC Outlet (2)
3.
Right side view
Cooling Fan
4.
E-Locking power
5.
Power model selector
6.
DC power (to battery)
7.
USB (Firmware update)
8.
LED display
9.
The Cooling Fan (item #4 above) will power on whenever the unit is plugged in for recharge.
The fan will run from a continuous, slow idle speed, to full speed, in order to minimize fan
noise in response to rising internal temperatures. The fan will also power on whenever the
On/Off AC Outlet Switch (item #2 above) is in the ON position regardless of recharging
status.

Set-Up and Calibration

The JACO Battery System is shipped in "cut-off" mode to prevent power drain during
shipping. Follow the steps below to activate the power system and calibrate the status LED
1
3
2
4
5 6 7
3
9
8
16