Specification - Jaco EVO User Manual

readout properly.
1. Integrate your PC or Laptop – After your Mobile Cart is unpacked and ready to go,
you should take the time to properly install the computer system as shown on page 8
of this Users Guide. Route all cables neatly and use the ty-wraps and Velcro pads
provided in the Cart Accessory kit.
2. Turn on power to the AC Outlets – Push the AC Switch shown as item 2 on page 13,
to the ON position. This switch can be accessed by opening the left-side enclosure
door, a screwdriver will be needed. The power switch is located on the left side of
the inverter/charger assembly as shown below.
3. Wake-up the Battery System – Plug the recharge power cord that is hanging from
the back of the Mobile Cart into any standard 120VAC wall outlet to activate the
Battery Power System.
4. Unplug the power cord – This step is necessary as you need to let the battery system
drain completely so that the status LED readout will be properly calibrated. Power
up the computer and LCD or the laptop to help drain the battery system.
5. Allow time to Calibrate – The status gauge readout at the front top of the Mobile
Cart needs to learn or calibrate as the power system charges from fully drained to
fully charged. Once the batteries are fully drained, plug in the power system and
leave the Mobile Cart plugged into the wall outlet until all 5 status LEDs are showing
green indicating that the batteries are fully charged. This step could take up to 2.5
hours.

Specification

 Model: L250 or L500
 Battery: Lithium Iron Phosphate also known as LiFePO4 and LFP
 AC Input: 100vac to 240vac
 Input Current: 3.5 amps
17