Jaco EVO User Manual page 10

opening. This will allow easy access for rebooting of the computer if needed.
Laptop: Open the laptop, place inside the top bay. Neatly rout the AC brick and cables into the
Top Bay with the power cord plugged into the internal power strip. Install the work surface so
that the laptop display protrudes through the opening, lock the work surface in place for
security.
All-In-One: The unit must have a 75mm or 100mm VESA pattern on the rear surface to mount
to the J1-20 Mobile Cart. The hardware to mount the All-In-One is provided.
It is highly recommended that you use the Velcro adhesive patches included with all Mobile
Carts inside the accessories kit to hold the PC, Thin Client, or Laptop in place inside the Mobile
Cart top assembly.
Installing LCD/LED Monitor:
Installing Keyboard & Mouse
When ordering your JACO Cart you have the option of including an integrated mouse and keyboard.
9
Our PC/LCD Mobile Carts ship with the LCD Stand in place
but the optional LCD not attached. A Phillips Head or (if
added security is needed for the LCD) Torx Head driver is
needed to attach the LCD to the LCD Stand, 4 places. Both
Phillips and Torx screws are provided. It is recommended
that one person hold the LCD while a 2nd person inserts
the hardware.
Make sure all 4 screws are installed and tightened
properly. Check with JACO Support if the LCD/LED Monitor
is more than 8 lbs. for proper counter weight calculation.
With the monitor and stand installed on the Cart, the LCD
power and signal cables can be installed. Route both
cables down through the cable management area of the
stand as shown to the left. Pull the cables into the Top
Assembly and attach to the PC or laptop computer that
will be installed later.