Change The Application Settings; Sample Name - Hach TitraLab AT1102 User Manual

Standard operations

7.4 Change the application settings

7.4.1 Sample name

38
The applications installed on the instrument have been pre-defined to optimize the measurement
process. Changing these default application parameters will have an effect on the measurement
process and measurement results. Only qualified personnel should change these parameters or
use the instrument in Expert mode. Refer to the application note before changing any
parameters.
In Basic mode changes to parameters are secure. In Expert mode changes to parameters are
not secure and can cause the application to run incorrectly.
Refer to Change application parameters
changed in basic and expert mode.
Refer to Sample name on page 38 for special features on the sample name.
1. From the home screen, select Settings.
2. Select Applications followed by Edit.
3. If more than one application is installed, choose an application to change from the
installed list and then push Edit.
4. Push the left and right arrow keys to jump to the previous or next parameter group.
Push the up and down arrow keys to scroll through the application parameters in the
parameter group.
5. The Edit key is only available when a parameter can be changed. Push Edit to
change the parameter. Enter the new details or select from a list.
Note: A description of the selected parameter is shown on the bottom of the display.
The two wildcard characters ? (question mark) and * (asterisk) can be used to
automatically increment the sample name.
Use the question mark character to increment the name using an integer. For example,
where Water is the name of the sample:
• Select Settings > Applications > Edit and change the sample name to Water ?
• The sample name for the first measurement is Water 1
• The sample name for the next measurement is Water 2, etc.
• The integer value is always set back to 1 when the instrument is set to off
Use the asterisk character in the name to increment the name using the instrument date
and time in YYMMDDHHMMSS format. For example, where Water is the name of the
sample:
• Select Settings > Applications > Edit and change the sample name to Water *
• The sample name for the first measurement made on 27th February 2015 at
15:30:25 is Water 150227153025
• The sample name for the next measurement made on 28th February 2015 at
16:32:47 is Water 150228163247, etc.
• The value is not reset when the instrument is set to off
Use both characters in the name to increment the name using an integer and the
instrument date and time. For example, where Water is the name of the sample:
• Select Settings > Applications > Edit and change the sample name to Water ? *
• The sample name for the first measurement made on 27th February 2015 at
15:30:25 is Water 1 150227153025
N O T I C E
N O T I C E
on page 63 for a list of parameters that can be