Safety Key Switch - Husqvarna LC 247Li Workshop Manual

18. Remove the screws. Remove the cover.
19. Assemble the motor in the opposite sequence. Use
the correct torque. Refer to
13 .

7.9 Safety key switch

7.9.1 To remove the safety key switch
1. Remove the blade. Refer to
the blade on page 22 .
2. Remove the motor from the chassis. Refer to
disassemble and assemble the motor on page 27 .
3. Put the motor cover on a cloth with the top down.
32 - Repair instructions
Servicing data on page
To remove and replace
To
4. Remove the 4 cables from the safety switch.
5. Remove the screw and washer.
6. Remove the safety switch.
7.9.2 To install the safety key switch
1. Put a new safety switch in the correct position as
shown in the illustration.
2. Attach the washer and tighten the screw.
3. Attach the cables to the correct position.
4. Assemble the motor. Refer to
assemble the motor on page 27 .
5. Attach the blade. Refer to
the blade on page 22 .
To disassemble and
To remove and replace
361 - 001 -