Table of Contents
Advertisement
F u l l-s i z e C P U C a r d
4.3 Installation 3:
Applicable for Windows NT 4.0
Insert the SBC-860 CD ROM into the CD-ROM Drive.
1.
2.
Start system with Windows NT 4.0 installed.
IMPORTANT: When the "Please select the operating system
to start..." message is displayed, select "Windows NT
Workstation Version 4.00 [VGA mode]".
From Start, select the Settings group, then click on the
3.
Control Panel icon.
4.
In the Control Panel, select the desired device and click on the
icon.
Follow the step-b y-step instruction and click on OK button.
5.
Click on the Have Disk... button.
6.
7.
Key in CD-ROM path and specify component drivers, then click
on the OK button.
8.
From the list of displayed devices, select your desired device.
9.
If a message appears stating the driver is already installed on the
system, and asks if you want to use the current or new drivers, be
sure to select the New button.
10. If prompted for the driver diskette a second time, click on the
Continue button.
(Notice: In some cases the system will ask you to insert
Windows NT CD ROM. Follow its instructions to complete
the setup procedures.)
11. When the message "The drivers were successfully installed"
is displayed, remove the display driver diskette, then click on the
OK button.
12. Reboot the system.
Chapter4 Drivers Installation
S B C - 8 6 0
4 - 4
Advertisement
Table of Contents
