Setting Jumpers - Aaeon SBC-860 Manual

Full-size CPU Card

2.4 Setting Jumpers

2.4 Setting Jumpers
2.4 Setting Jumpers 2.4 Setting Jumpers 2.4 Setting Jumpers
Configure your card to meet the needs of your applications by
setting jumper which is the simplest electric switch. It consists of
two metal pins and a small metal clip (often protected by a plastic
cover) that slides over the pins to connect them. To close a jumper,
connect the pins with the clip. To "open" a jumper, please remove
the clip. Sometimes a jumper will have three pins, labeled 1, 2, and
3. In this case you would connect either pins 1 and 2 or 2 and 3.
Open
The jumper settings are schematically depicted in this manual as
follows:
Open
A pair of needle-nose pliers may be helpful when working with
jumpers.
If you have any question about the best hardware configuration for
your applications, contact your local distributor or sales represen-
tative before you make any change.
2 - 8 Chapter 2 Quick Installation Guide
SBC-860
SBC-860
Closed
Closed
BC-599/596
3
2
1
Closed 2-3
1 2 3
Closed 2-3