freightliner Run Smart ARGOSY Driver Manual page 33

Instruments
If the fault is still active 30 seconds after the mes-
sage is dismissed, the warning message will come
on again.
High Coolant Temp
This message and an audible warning come on
whenever the engine coolant temperature exceeds
the maximum allowable temperature.
If the fault is still active 30 seconds after the mes-
sage is dismissed, the warning message will come
on again.
Low Voltage
On some vehicles, this optional message and an au-
dible warning come on whenever the ICU detects a
low voltage condition.
Turn Signal On
This warning message and audible warning come on
whenever the turn signal remains on for four minutes
or five miles of travel.
To dismiss this message, either turn off the turn sig-
nal or tap any key.
Service Warnings
Service warning screens display during the ignition
sequence and indicate that a service interval has
been reached or exceeded and maintenance is re-
quired. The messages may indicate the number of
miles (KM) or hours until the next required service or,
once passed, the number of miles (KM) or hours ago
that maintenance should have been performed.
Automated Transmission Display
The ICU4M can display current gear information for
vehicles with an automated transmission. The last
three digits at the far right on the lower line of the
driver display screen are reserved for this informa-
tion.
If there is a request to shift, an up or down arrow is
also displayed, depending on the shift direction.
On vehicles with conventional manual or automatic
transmissions, the gear and shift direction are not
displayed. For more information about specific
models of automated transmissions, see
4.11
Mobile Screens
The following screens are available when the parking
brake is off (when the vehicle is mobile).
i. Fasten seat belt (rpm<100)
ii. Fuel economy (rpm>100)
iii. Odometer
iv. Trip distance/hours
v. Trip advisory
vi. Leg distance/hours
vii. Leg advisory
viii.
Outside air temperature
ix. Fuel used/average MPG (KM/L)
Stationary Screens
NOTE: Metric unit screens are similar. AMT=
Current gear information for automated manual
transmissions.
The following screens are available when the parking
brake is on (when the vehicle is stationary).
i. Odometer
ii. Trip information including trip miles/hours, idle
hours, average speed, leg miles/hours
iii.
Fuel information including fuel used, fuel
economy, idle/PTO fuel usage
iv. Engine information including engine miles/hours,
engine/PTO gallons, oil level
v. Diagnostic information
vi.
Service information including mileage or time to
next service
vii. Setup information
viii. Vehicle information including Datalink status, ICU
serial number, software version
ix. Fasten seat belt warning
Trip Information
When idle hours are displayed, tap the any key to
Chapter 8.
access the main trip information screen. See
Fig. 4.9. Tap the arrow keys on the 10-key keypad to
advance through the screens. Press and hold the
SET/RESET key to reset any of the screens.