Table of Contents
Advertisement
Checking the Configuration
Table 4-3
Using show Commands (continued)
Command
show c7300
show interfaces pos
slot-number/interface-number
show controllers pos
slot-number/interface-number
show protocols
show running-config
show startup-config
If an interface is shut down and you configured it as up, or if the displays indicate that the hardware is
not functioning properly, ensure that the interface is properly connected and terminated. If you still have
problems bringing up the interface, contact a service representative for assistance. This section includes
the following subsections:
•
•
•
•
Choose the subsection appropriate for your system. Proceed to the
Network Connectivity" section on page 4-11
Using the show version or show hardware Commands
Display the configuration of the system hardware, the number of each interface type installed, the Cisco
IOS software version, the names and sources of configuration files, and the boot images by using the
show version (or show hardware) command.
Note
The outputs that appear in this document may not match the output you receive when running these
commands. The outputs in this document are examples only.
Cisco 7304 Router
Following is an example of the show version command from a Cisco 7304 router with the OC12 POS
line card:
Router# show version
Cisco Internetwork Operating System Software
IOS (tm) 7300 Software (C7300-JS-M), Version 12.1(10),
Copyright (c) 1986-2002 by cisco Systems, Inc.
OC12 Packet Over SONET Line Card Installation and Configuration
4-8
Function
Displays types of line cards with
status information for each
installed line card
Displays status information
about the OC-12 interface in a
Cisco 7304 router
Displays all the current interface
processors and their interfaces
Displays protocols configured
for the entire system and for
specific interfaces
Displays the running
configuration file
Displays the configuration
stored in NVRAM
Using the show version or show hardware Commands, page 4-8
Using the show diag Command, page 4-9
Using the show c7300 Command, page 4-10
Using the show interfaces Command, page 4-11
Chapter 4
Example
Router# show c7300
Router# show interfaces pos 3/1
Router# show controllers pos 3/1
Router# show protocols
Router# show running-config
Router# show startup-config
"Using the ping Command to Verify
when you have finished using the show commands.
Configuring the OC12 POS Line Card
OL-3437-01
Advertisement
Table of Contents
