Table of Contents
Advertisement
Chapter 1
Overview
Table 1-4
Identifying Interface Addresses
Platform
Cisco 7304 router
1. Slot 0 and slot 1 are reserved for the network services engine (NSE).
Cisco 7304 Router Interface Addresses
This section describes how to identify the interface addresses used for the OC12 POS line card in a
Cisco 7304 router. The interface address is composed of a two-part number in the format
slot-number/interface-port-number. See
In a Cisco 7304 router, slots are numbered, beginning with slot 0 (a dual-width slot reserved for the
NSE-100) on the bottom, and continuing from the lower left to the upper right through slot 5.
Note
The NSE-100 is the only card supported in slot 0.
The interface address of the interface on an OC12 POS line card in slot 2 is 2/0 (slot 2 and interface 0).
If the OC12 POS line card was in slot 4, this same interface would be numbered 4/0 (slot 4 and
interface 0).
OL-3437-01
Interface Address Format
Slot-number/interface-port-number
Numbers
Slot—0 through 5
Table 1-4
for the interface address format.
OC12 Packet Over SONET Line Card Installation and Configuration
Identifying Interface Addresses
Syntax
1
2/0
1-11
Advertisement
Table of Contents
