Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Minuteman X829 Asbestos Series
Summary of Contents for Minuteman X829 Asbestos Series
- Page 1 Parts and Instruction Manual X829 Asbestos Series 4 & 6 Gallon...
- Page 2 This manual is furnished with each new MINUTEMAN X829 Asbestos Vac. This provides the neces- sary operating and preventive maintenance instructions. Operators must read and understand this manual before operating or servicing this machine. This machine was designed to give you excellent performance and efficiency. For best results and minimal cost, please follow the general guidelines below: ·...
-
Page 3: Table Of Contents
Lid Assembly ........................... 6 Lid Assembly BOM .......................... 7 Adapter Assembly ........................... 8 Tank Assembly ..........................9 Bag Assembly ..........................10 Optional Industrial Tools and Accessories ..................11 Minuteman International Made Simple Commercial Limited Warranty ........12 Parts and Instruction Manual... -
Page 4: Important Safety Instructions
FOR COMMERCIAL USE ONLY IMPORTANT SAFETY INSTRUCTIONS When using an electrical appliance, basic precautions should always be followed, including the following: READ ALL INSTRUCTIONS BEFORE USING WARNING - To reduce the risk of fire, electric shock, or injury: • Do not leave appliance when plugged in. Unplug from outlet when not in use and before servicing. -
Page 5: Inspection
Inspection Carefully unpack and inspect your machine for shipping damage. Each unit is tested and thoroughly inspected before shipment, and any damage is the responsibility of the delivery carrier who should be notified immediately. Electrical - 115 Volt This machine is designed to operate on a standard 15 amp. 115 volt, 60 hz, AC circuit. Voltages below 105 volts AC or above 125 volts AC could cause serious damage to the motor. -
Page 6: User Maintenance Instructions
Use only approved Minuteman Asbestos Vacuum filters and filter bags. Before attempting to use and before cleaning, be certain that you fully understand the instructions given for the setting up or cleaning/changing of filters of this vacuum. -
Page 7: Tank/Filter Set-Up Procedure
Tank/Filter Set-Up Procedure 1. When using the poly adapter for dry pick-up follow the described procedures below. A. Insert poly bag (5) into tank assembly draping all excess bag height over edge of tank. Fully open bag inside tank to ensure that bag is not bunched up and fully extended to bottom of tank. -
Page 8: Warning Instructions For 800012 & 805037 Plastic Bags
WARNING INSTRUCTIONS FOR 800012 & 805037 PLASTIC BAGS TO PREVENT OVERHEATING AND DAMAGE TO THE MACHINE PLEASE FOLLOW THE INSTRUCTIONS BELOW! After placing the plastic recovery bag inside the tank, use a sharp knife to cut a 1” slit in the bag at the top edge of the tank, on the side opposite the vacuum intake. -
Page 9: Exploded Views
Exploded Views Lid Assembly Parts and Instruction Manual Page 6... -
Page 10: Lid Assembly Bom
Lid Assembly BOM ITEM PART NO. REQ’D DESCRIPTION 110029 FILTER-ULPA, X829 SERIES 110030PKG PREFILTER SLEEVE, 829/839, PKG OF 6 290017 MOLDED VAC MOTOR GASKET 290031 LID GASKET 294/6 DIECUT 290032 DOME SEAL 296 380001-4 MOTOR-VAC 120V (ECM) 380054 MOTOR-VAC 240V 380005 CARBON BRUSH REPLACEMENT (ECM) 380028... -
Page 11: Adapter Assembly
390110 Intake Assembly Aluminum 712530 SCR-MC 10 - 24 x .62 SS 712565 SCR-MC 1/4 - 20 x .62 SS 715381 Decal, Minuteman .8x5.5 Lt Gry 800421 Filter Insert Screen 800423 Latch Plate Zinc PLT 828893 Rivet Pop Parts and Instruction Manual... -
Page 12: Tank Assembly
Tank Assembly Item Part No. Qty. Description 130032 Cap Retainer 280016 Caster - 3” w/3/8 x 518 Stem 711005 SK ¼-20 x .31 711006 SK ¼-20 x .62 711503 WSR-Flat #10 711524 WSR-Wave .52 x .87 x .01 711594 WSR-Flat .56 x .88 x .03 Nickel 711713 Ret Ring-E Ext .50 711915... -
Page 13: Bag Assembly
Bag Assembly Item Part No. Qty. Description 711903 Pop Rivet .19x.44 AL 712764 Washer #10 SS 760244MCH Plastic Bag Frame w/Hole 760406PLT Bag Frame 6 Gal Plated 805040 Cloth Bag Only 6G 800056 Bag Assy. w/Frame 6 Gal Parts and Instruction Manual Page 10... -
Page 14: Optional Industrial Tools And Accessories
Optional Industrial Tools and Accessories 800317 Hose Assy. 1 1/2" x 10’ 390014 Hose Cuff 801044 Hose 290000 Wand Assy. 1 1/2, Complete 290001 Upper Wand 290002 Lower Wand 800035 12” Crev Tool Complete 800083 3" Rd Dust Brush, Complete 133249 Dust Brush HSG 3”... -
Page 15: Minuteman International Made Simple Commercial Limited Warranty
A potential health hazard exits without original equipment replacement. All warranted items become the sole property of Minuteman or its original manufacturer, whichever the case may be. Minuteman disclaims any implied warranty, including the warranty of merchantability and the warranty of fitness for a particular purpose.