Tank/Filter Set-Up Procedure - Minuteman X829 Asbestos Series Parts And Instruction Manual

1. When using the poly adapter for dry pick-up follow the described procedures below.
A. Insert poly bag (5) into tank assembly draping all excess bag height over edge of
tank. Fully open bag inside tank to ensure that bag is not bunched up and fully
extended to bottom of tank.
B. Depending on weight of dry material being recovered, it may be necessary to slit
poly bag 2" horizontally approximately 2" down from top of tank. This will stop poly
bag from closing in on bottom on poly adapter. After filling bag, tie off bag below slit
and remove from tank.
2. Install poly 1:1 adapter (4) on top of tank assy. (6) as shown and snap tank latches.
3. Install filter protector (3) over cloth filter (2) and place in poly 1:1 adapter (4).
4. Position vacuum motor lid assy. (1) on top of poly 1:1 adapter and snap lid latches in
place.
Parts and Instruction Manual

Tank/Filter Set-Up Procedure

1. Vacuum motor lid assembly
2. Cloth filter with frame
3. Filter protector
4. 1:1 Poly adapter
5. Plastic liner for top fill dry pickup
6. 4/6 gallon tank
Page 4