Step 2-Upload The Data To The Shop Computer - Bosch CH-47976 User Manual

Viewing Test Results
Step 2—Upload the Data to the Shop Computer
1. Turn the MCU on.
2. Start the AFIT PC Application (if not already running).
3. Check the Selected COM Port Num and Connectivity Status at the bottom of the
application window.
• If the Connectivity Status indicator is green, proceed to step 4.
• If the Connectivity Status indicator is red or a message is displayed, you need to free the
selected COM Port from another application or select another available port:
From the Setup menu select Choose Port and select one of the available ports.
4. Select ADD NEW, or EDIT existing customer/vehicle information.
ADD NEW—use to save first record to a new customer file
EDIT—use for adding second test data to an existing customer
Note: the AFIT PC application stores only two test data records for each customer info
record—Balance 1/Flow 1 and Balance 2/Flow 2.
The first set of test results uploaded to a customer record are displayed in the
BALANCE 1/FLOW 1 graph and table. The second set of test results uploaded are displayed
in the BALANCE 2/FLOW 2 graph and table. Additional uploads to that customer record will
overwrite the BALANCE 2/FLOW 2 data.
TIP: To store additional test results, create a new customer record for that particular customer.
5. Click Load Injector Data in the AFIT PC application. IMPORTANT! To avoid corrupting
the data, make sure the MCU is powered on before selecting.
6. On the MCU navigate to, and select Upload Test Results. Once AFIT completes the upload,
the unit returns to the Injector Test menu and the AFIT PC application displays the uploaded
test results.
7. In the AFIT PC application, click SAVE to retain information, or CANCEL to discard. Retained
customer records may be printed as reports at anytime.
For further details on using the AFIT PC application, please refer to the application's help file.
32 Active Fuel Injector Tester User Guide