Uploading Test Data To A Shop Computer; Step 1-Connect The Main Control Unit To The Computer - Bosch CH-47976 User Manual

Injector Test
Run New Test
View Test Results
Upload Test
Results

Uploading Test Data to a Shop Computer

You will use the AFIT PC application software to upload the test data to the shop computer, view,
print, and save the tests results. Before you begin, make sure the software is installed on the
computer. Note: If you need to use the USB serial port adapter, you will need to install the USB
serial port adapter software driver included on the AFIT CD if you have not already installed it.
Step 1—Connect the Main Control Unit to the Computer
Prior to connecting to the computer for download, you may (but not required) disconnect the
FMU, DLC adapter, injector harness (if used), and FPEA cable (if used) from the MCU.
1. Connect a serial cable to the MCU
and to the computer.
Note: If the computer does not
have an available serial port,
connect the USB adapter to
the serial cable and connect to
an available USB port on the
computer.
2. Use vehicle power or connect the
wall outlet adapter to the MCU
and plug into an electrical outlet.
Main Menu
Pressure Test Leak Down Test Vehicle Selection
Main Control Unit
USB serial To electrical
port adapter outlet
Active Fuel Injector Tester User Guide
Viewing Test Results
Utility Functions
To computer's serial port
(or USB serial port adapter)
31