Leb Electronics STONE 230 Instructions And Warnings For Installation, Use And Maintenance page 13

Please read these instructions carefully before installing the
device as they contain important information concerning safety,
installation, use and maintenance.
- This manual is intended but for qualified technical staff and not for
end user. It is a task of the installer to inform afterwards user on the
use of the automatism and on possible dangers could come from it,
as well as on the need of a periodical maintenance.
- The set up is to be carried on only by qualified staff having got
required technical and professional requirements.
- The product is to be installed complying with rules in force about
computer-based closings.
- The device has been realised expressly to automate wing gates.
Any other employ is to be considered improper and therefore
forbidden.
- Always use original components. The Company LEB doesn't take
any responsibilities for damages due to the use of non-original
components.
- Before proceeding with set up, make sure the gate frame is solid
and fitted for the employ of the device.
- Before proceeding with set up, make sure that, during the gate
move, there are not friction points and that this one has no
possibilities to unhook from the pillar.
- Before acting on the device, check the power supply voltage is
disconnected.
- Use the device on respecting the technical limits described in the
following manual (see page 12).
- The equipment is not to be handled by children or incompetents.
- In case of lack of electric voltage, start the unblocking device to
manually open or close the gate.
- The maintenance of the device is to be executed but by qualified
staff authorized by the Manufacturer.
- Check the condition of the gate hinges any six months and lubricate
them when necessary.
Warnings
- 12 -
ENGLISH