Table of Contents
Advertisement
9. Clean the glass panel with water and
soap. Dry the glass panel carefully.
When the cleaning is completed, do the
above steps in the opposite sequence.
Install the smaller panel first, then the
larger and the door.
One of the hinge-arms
(normally the right one) is
free to move. Make sure,
that both hinge-arms are in
the same position
(approximately 70° angle).
WARNING!
Make sure that the glasses
are inserted in the correct
position otherwise the
surface of the door may
overheat.
10. TROUBLESHOOTING
WARNING!
Refer to Safety chapters.
10.1 What to do if...
Problem
The cooking zones do not
operate.
The oven does not heat
up.
The oven does not heat
up.
The lamp does not oper‐
ate.
9.5 Replacing the lamp
1. Turn off the oven.
Wait until the oven is cooled down.
2. Disconnect the oven from the mains.
3. Put a cloth on the bottom of the
The top lamp
1. Turn the lamp glass cover to remove
2. Clean the glass cover.
3. Replace the lamp with a halogen,
4. Install the glass cover.
Possible cause
Refer to the operating instructions for the built-in cook‐
ing surface.
The oven is deactivated.
The fuse is blown.
The lamp is defective.
WARNING!
Risk of electric shock.
The lamp can be hot.
cavity.
it.
230 V, 40 W, 300 °C heat resistant
lamp.
Remedy
Activate the oven.
Make sure that the fuse is
the cause of the malfunc‐
tion. If the fuse is blown
again and again, contact a
qualified electrician.
Replace the lamp.
ENGLISH
25
Advertisement
Table of Contents
