Operating Instructions; Using Osd Controller; Description Of The Joystick Operation - Eneo MPC-52C0000M0A Quick Installation Manual

Operating instructions

Using OSD controller

Setup menu can be accessed and controlled by OSD control joy stick on the rear of
the camera unit. Five commands are available with the joy stick.
OSD Control Joy Stick
Description of the OSD control operation
1. SET ( ) : Access to the menu or enter the setting. To enter the main menu,
●
press the Set Key down.
2. UP/DOWN (▲/▼) : Choose the desired sub-menu and to move the cursor up
or down.
3. LEFT/RIGHT (◄/►) : Set up the value of the selected menu. Used to adjust the
desired menu selection and to move the cursor left or right.
4. ' ' denotes the long press down straightly for about 2 seconds
i
ANALOG OUT0 should be set to TVI MODE, AHD MODE or CVI MODE to get CVBS
video in sub-out. If it is set to CVBS, there is no CVBS video in sub-out port. (SYSTEM>
OUTPUT> ANALOG OUTPUT0)
i
If CVBS video is enabled through ANALOG OUT0 or Sub-out port, WDR and 3D-NR
functions are disabled in all video outputs. It should be considered when installer
adjusts the video with installation monitor via CVBS video signal.
CVBS/HD-A
CONTROL
CVBS HD-A
POWER
EN
9