Advertisement
Supplemental Instructions for the Vision SLR Lightbar with Standalone SignalMaster
Introduction
This publication provides supplemental instructions for installing the Vision
SignalMaster
to a vehicle.
™
Unpacking the Kit
After unpacking the kit, inspect it for damage that may have occurred in transit. If it has been damaged, file
a claim immediately with the carrier stating the extent of damage. Carefully check all envelopes, shipping
labels, and tags before removing or destroying them. Ensure that the parts shown in Table 1 are contained
in the packing carton (Table 1). If you are missing any parts, contact Customer Support at 1-800-264-
3578, 7 a.m. to 5 p.m., Monday through Friday (CT). Also required is an installer-supplied control head for
controlling the functions of the lightbar.
Mounting the SignalMaster
IMPORTANT: Plan all cable routing before completing the installation. Plan the location of the wire-
routing hole so that the cable does not have tight bends.
To mount the SignalMaster:
1. Determine the desired distance between the mounting holes and attach the mounting brackets to the
SignalMaster with the #10 Torx screws.
2. Mark the positions of the two mounting holes and the hole for the cable.
2
Qty.
Description
1
Connector, Female, 8-Position
1
Connector, Male, 8-Position
2
Bracket, Mounting
4
Screw, #10 Type B, Pan Torx
2
Nut,1/4"-20 Keps
LOCATING OPERATOR CONTROLS—Locate the light system controls so the vehicle
and controls can be operated safely under all driving conditions. Failure to heed this
caution could result in driver distraction or driver error while operating the vehicle.
ROOF SUPPORT STRUCTURE—There is a roof support member that spans the
distance between the driver and passenger side. DO NOT DRILL THROUGH THIS
MEMBER! Adjust any hole locations until the holes can be drilled without going
through this member. Failure to follow this warning will weaken the roof of the
vehicle and may lead to an increased chance of bodily injury or death in a roll-over
accident.
SIGNALMASTER ORIENTATION—The SignalMaster lightbar must be oriented
correctly for proper operation. The assembly should be installed with the ROC board
on top.
Table 1 Kit contents
Blk SS
®
, SS
®
Vision SLR Lightbar
®
SLR lightbar with Standalone
Part No.
140325-06
140333-08
8652180
7011246-06
7058050
Advertisement
