Table of Contents
Advertisement
Unpacking the Light Bar
After unpacking the ILS light assembly, inspect it for damage that may have occurred in
transit. If it has been damaged, do not install it. File a claim immediately with the carrier,
stating the extent of damage. Carefully check all envelopes, shipping labels, and tags
before removing or destroying them. Ensure that the parts listed in kit contents list are
included in the package. If you are missing any parts, contact Customer Support at
1-800-264-3578, 7 a.m. to 5 p.m., Monday through Friday (CT).
Introduction to the SIF Series SpectraLux
The SIF SpectraLux ILS is a single-level LED light bar that mounts on the inside of the
front windshield. SIFM is center-focused; SIFZ is off-axis. It uses ROC (Reliable On Board
Circuitry) technology, and Solaris
The light bar operates at a nominal input of 13.6 Vdc (11 Vdc minimum). Both Discrete
(SIFM, SIFZ) and Serial (SIMFJ, SIFZJ FSJoin
Discrete models have eight control inputs that connect to the user supplied low-current
switches. Serial models are controlled through the CAT5 serial communication cable. The
cable connects to Federal Signal Convergence network controllers, or the Convergence
Serial Interface Module (Part Number 858303641). With the Serial Interface Module, the
lightbar can be activated by Federal Signal lightbar controllers or individual low-current
switches.
The backbone is a powder coated aluminum shroud. The light bar has 15-foot power and
ground cables and a 25-foot control cable. Mounting hardware is a configured option.
Refer to mounting instructions supplied with mounting hardware. The light bar has an
operating temperature range of –30°C to +65°C (–22°F to +149°F).
FSJoin
Spectralux SIFxJ ILS models with FSJoin allow flash patterns to synchronize with other
FSJoin compatible devices. You can program light bar patterns and features on an
individual light head basis with the Convergence Network Configuration Software.
Outputs or light heads set to the same flash rate automatically synchronize. You can
program a variety of system features with the Convergence Network Configuration
Software (available on the Federal Signal website at www.fedsig.com). Programming
requires an FSJoin compatible controller such as a Pathfinder ® Siren/Light Controller.
Programming does not require disassembling or removing any hardware from the vehicle.
Installation, Maintenance, and Service Manual
Federal Signal www.fedsig.com
Introduction to the SIF Series SpectraLux®
®
S2 reflectors. Split and Passenger only are available.
®
) control are available as configured options
™
9
Advertisement
Table of Contents
