Advertisement
3. Drill two mounting holes 0.257" to 0.265" in diameter and a hole 0.375" in diameter for the cable.
4. Secure the SignalMaster to the vehicle with the 1/4"-20 Keps nuts.
ALUMINUM EXTRUSION
Connecting the 8-Position Connectors
8-POSITION CONNECTOR PRECAUTION—The 8-position connector is not
waterproof. Before cutting the SignalMaster cable, determine the cable lengths
required to ensure that the cable connector is located in a dry location inside the
vehicle.
To electrically connect the SignalMaster to the Vision SLR:
1. Cut the SignalMaster cable to length and route it to the chosen connection point.
2. Strip and connect the eight SignalMaster control wires as shown in Figures 2 and 3 on page 4. Keep the
pairs twisted together, separating them just enough to insert the ends into the connector.
3. Ensure that each SignalMaster control wire is in the proper position. Connect the 8-position connectors
together, and apply pressure until they lock.
4.
After installation, test the light system to ensure that it is operating properly.
5. Test all vehicle functions, including horn operation, vehicle safety functions, and vehicle light systems,
to ensure proper operation. Ensure that the installation has not affected the vehicle operation or changed
any vehicle safety function or circuit.
Supplemental Instructions for the Vision SLR Lightbar with Standalone SignalMaster
Figure 1 Mounting brackets attached to SignalMaster
STUD FOR 1/4"-20 KEP NUT
#10 TORX SCREW (4)
MOUNTING BRACKET (2)
Vision SLR Lightbar
SIGNALMASTER
290A6778
3
Advertisement
