Valor H3 Series Installation Manual page 3

Install Appliance with 1030 Clean Installation Kit
The side brackets provided loose with the appliance are
not needed with this kit.
Hearth considerations
You need to know whether there will be a hearth or
not in front of the appliance and some rules must be
considered:
Without hearth (up the wall)
In the case where there is no hearth, the wall fi nish
can extend up to the fl ange at bottom of 1030CIK. See
diagram.
With hearth
Combustible hearths and fl ooring are allowed providing
they are fl ush with, or below, the bottom of the
appliance. Hearths raised above the bottom of the
appliance (max. 1-5/8" thick) will need to be constructed
of non-combustible material and use a thermal break
such as Micore between the non-combustible fi nish
and any combustible sub-fl oor below.
Raising the appliance further will help reduce fl oor
temperatures.
Installation at time of framing
1. Align the appliance with the cavity, and push it in
until the front face is fl ush with the studs.
2. Install the lower panel using the three bolts at the
base of the appliance (3 nuts).
3. On the appliance, install the side panels as indicated
(3 x 1/2" screws per side).
4. Slide the convection baffl e in to the front of the ap-
pliance, then attach upward into the liner box (3 x
3/8" screws).
3