Thales TTT-Compact II Manual page 9

6) Setting and adjusting speed
The two push-buttons at the front, labelled with "33" and "45" are to be used to start and stop
the platter on the speed indicated. The push-buttons do have an integrated light, showing the
actual status of the turntable:
- Blinking single light: acceleration phase of the platter
- Steady: Platter turns on the speed indicated
- Blinking both lights: Low battery status is indicated by the blinking of both lamps. The
battery will still have enough charge to drive the TTT for at least one more hour.
The speed of the turntable was set in our factory using most precise equipment. This setting is
stable for a long time period. If re-adjusting is needed, use the specific adjusting-key (1) deliv-
ered with the TTT-Compact II.
The adjusting-key is set thru the hole at the front of the TTT-Compact II and connected to the
internal potentiometer. Turning the key clockwise will decrease; turning it anticlockwise will
increase the speed of the platter.
7) Clamp
The TTT-Compact II is delivered with a record-clamp designed for this turntable specifically. This
clamp is working harmonically with the high density inlay of the main platter. It reduces vibra-
tion and deformation of the record itself and ensures steady contact between platter and rec-
ord. Please plug the clamp carefully on the spindle of the turntable. The clamp is not screwed
or tightened, but operates with its mass only.
8) Cleaning
For cleaning the TTT-Compact II, please use a soft and clean towel. The high density inlays of
the platter and the clamp shall be cleaned with a wet microfiber towel. For this process, please
use water only, neither cleaning nor dissolver-liquids.
Page 9/10
45
1
2
33