An Error Message Appears On The Screen - Siemens SIMATIC PC RI25 Manual

Error Diagnostics
4.8

An Error Message Appears on the Screen

Error
The following table describes the error messages that the BIOS system
Messages
outputs. Error messages the operating system or program outputs are
described in the manuals for these programs.
Press <F2> to call Setup when booting the computer.
Error Message on the Screen
Address conflict
Combination not supported
I/O device IRQ conflict
Invalid System Configuration Data Plug & Play problem
Allocation Error for
System battery is dead
Replace and run SETUP
System CMOS checksum bad
Run SETUP
Incorrect Drive A type
Run SETUP
Incorrect Drive B type
Run SETUP
Diskette drive A error
Diskette drive B error
4-10
Meaning/Suggestion
Plug & Play problem
Contact your technical support team.
Plug & Play problem
Contact your technical support team.
Plug & Play problem
Contact your technical support team.
Set the RESET CONF...DATA option in the Setup.
Contact your technical support team.
Plug & Play problem
Please undo the last hardware change.
Contact your technical support team.
The battery on the CPU module is defective or dead.
Contact your technical support team.
Call up SETUP and save. If this message appears
during each power up, contact your technical support
team.
Check the SETUP entries for Drive A.
Check the SETUP entries for Drive B.
Error accessing Drive A.
Contact your technical support team.
Error accessing Drive B.
Contact your technical support team.
C79000-G7076-C806-01
SIMATIC PC RI25/45