Table of Contents
Advertisement
3.3
Setting Up Your PC
Overview
The operating system and the system software for your PC were
factory-installed on the hard drive. The SIMATIC PC RI25 has MS-DOS
6.22. The SIMATIC PC RI45 has the multi-language version of
Windows 95.
You must differentiate the following two instances when you switch on your
PC:
Initial startup
Complete restart
Initial Startup
Your PC software is set up during the initial startup. Proceed as follows:
1. Switch on your PC.
2. Set the monitor's brightness control switch to bright. (Refer to the
operating instructions for the monitor.) Switch on the monitor.
The PC conducts a self-test. The following message appears briefly
during the self-test:
3. Wait until the message disappears and then follow the instructions on the
screen.
Your operating system loads after the self-test is finished. The loading
procedure depends on the operating system and therefore varies,
depending on your PC variation (Sections 3.4 and 3.5).
Complete
Once your PC is set up, the operating system interface will be automatically
Restart
displayed after the startup procedure every time you switch on or reset the
PC.
SIMATIC PC RI25/45
C79000-G7076-C806-01
Setting Up and Operating Your PC RI25/45
Press <F2> to enter SETUP
3-5
Advertisement
Table of Contents
