An Error Message Appears On The Screen - Siemens SIMATIC RI45 PII Series Product Information Bulletin

Error Diagnostics
6.8

An Error Message Appears on the Screen

Error Messages The following table describes the error messages that the BIOS system
outputs. Error messages the operating system or program outputs are
described in the manuals for these programs. Press <F2> to call Setup when
booting the computer.
Error Message on the Screen
Address conflict
Combination not supported
I/O device IRQ conflict
Invalid system configuration data
Allocation error for
System battery is dead
Replace and run SETUP
System CMOS checksum bad
Run SETUP
Incorrect drive A type
Run SETUP
Incorrect drive B type
Run SETUP
Diskette drive A error
Diskette drive B error
Failure fixed disk
Keyboard error
Stuck key
K system RAM failed at offset:
K shadow RAM failed at offset:
K extended RAM failed at offset:
Failing bits:
Operating system not found
Previous boot incomplete
Default configuration used
System cache error
Cache disabled
Monitor type does not match
CMOS
Run SETUP
System timer error
Real-time clock error
Keyboard controller error
6-6
Meaning/Suggestion
Plug & play problem
Contact your technical support team.
Plug & play problem
Contact your technical support team.
Plug & play problem
Contact your technical support team.
Plug & play problem
Set the RESET CONF...DATA option in the Setup.
Contact your technical support team.
Plug & play problem
Please undo the last hardware change.
Contact your technical support team.
The battery on the CPU module is defective or dead.
Contact your technical support team.
Call up SETUP and save. If this message appears during each power up, contact
your technical support team.
Check the SETUP entries for drive A.
Check the SETUP entries for drive B.
Error accessing drive A.
Contact your technical support team.
Error accessing drive B.
Contact your technical support team.
Error accessing the hard drive.
Contact your technical support team.
Check whether the keyboard is connected correctly.
Check whether a key on the keyboard is stuck.
Memory error. Contact your technical support team.
Memory error. Contact your technical support team.
Memory error. Contact your technical support team.
Memory error. Contact your technical support team.
Possible causes:
No operating system present
Incorrect drive addressed (diskette in drive A/B)
Incorrect active boot partition
Incorrect entries in SETUP for the BOOT drive
Four times abort of the previous BOOT procedure, for example, due to a power
failure. Check the hardware settings and the SETUP.
Error in the CPU's cache module.
Contact your technical support team.
The monitor does not match the SETUP entries.
Adapt the SETUP entries to the monitor.
Hardware error
Contact your technical support team.
Clock chip error
Contact your technical support team.
Keyboard error
Contact your technical support team.
Product Information Bulletin RI45 PII
C79000-Z7076-C814-02