Mounting
4.4 Mounting bus adapters
Required tool:
● Slotted screwdriver, blade width 3 to 3.5 mm
or
● Torx screwdriver, size T10
Installation
Figure 4-1
To fit a bus adapter, follow the steps below:
1. Turn off the power to the device.
2. Remove the cover of the bus adapter slot.
3. If necessary mount a strain relief, see section "Mounting tensile strain relief (Page 23)".
4. Plug the bus adapter parallel into the BaseUnit until it can be heard to lock in place
5. Screw the bus adapter to the BaseUnit of the device with the supplied screw (tightening
torque 0.2 Nm)
Use the specified tool for this.
6. Insert the connection plugs into the sockets intended for this on the bus adapter.
Removal
To remove a bus adapter, follow the steps below:
1. Turn off the power to the device.
2. Remove all connected cables from the BusAdapter.
3. Loosen the screw connection of the bus adapter.
4. Pull the bus adapter out of the Base Unit to the front.
22
Mounting bus adapters
②
.
Operating Instructions, 06/2018, C79000-G8976-C472-01
①
.
SIMATIC BusAdapter