Table of Contents
Advertisement
System Configuration
System configurations using peripherals and related devices
are shown in the figures below.
The PLD and software versions installed with the devices to be
used should be updated.
Notes
• Make the adjustments required for shooting with the
cameras before connection.
• For 3D operation, be sure to use two cameras of the same
model.
• In 3D mode, the left camera functions as the main camera.
Adjusted values registered for the left camera take priority.
3D multicamera system operation example
Standalone operation example (two cameras)
HDC-P1
(Right camera)
HDFA-200
HDC-P1
(Left camera)
• Production of some of the peripherals and related devices
• Power capacity supplied from the DC OUT connectors is
HDVF-C950W/C730W/
C550W/EL75 Viewfinder
CAM-SUB ( R )
CAM-MAIN(L)
CAM-MAIN(L)
CAM-SUB(R)
SDI1 OUT
SDI2 OUT
TEST OUT
PROMPTER1/
REMOTE
REF OUT
SDI IN
REF OUT
SDI IN
GENLOCK IN
CAM-MAIN(L)
CAM-SUB(R)
AUDIO IN 1
AUDIO IN 2
DC IN
DC OUT
DC OUT
DC OUT
4A max
AUX
MIC
MIC
LINE
+48V
LINE
+48V
OFF
AES/EBU
OFF
CAM-MAIN ( L )
The right camera follows the left camera other than for offset
setting items.
shown in the figures might be discontinued. For advice on
choosing devices, please contact your Sony dealer or a
Sony sales representative.
limited.
For details, see "Notes on Power Supplied from This Unit"
(page 14).
Picture monitor
CAM-SUB(R)
REMOTE
VF
REMOTE
SDI1 OUT
CRANE
TRACKER
RET CTRL
DC OUT
0.5A max
DC IN
AC Adaptor
AC-DN10/DN2B
RCP-1500/1501/1530
Remote Control Panel
SR recorder
AC power
7
Overview
Advertisement
Table of Contents
