Connecting A Camera Control Unit (Ccu) - Sony HDFA-200 Operation Manual

Connecting a Camera Control Unit
(CCU)
Connecting the unit and a CCU
A camera control unit (CCU) to be connected to this unit
requires that an HKCU-HB10/HB15 3G Fiber Transmission
Unit be mounted. Connect the unit and CCU, following the
procedures below.
1
Remove the cap from the fiber connector of this unit.
2
Connect the CCU connector on the unit and the
CAMERA connector on a CCU, using an optical fiber
cable.
3
Set the CAMERA POWER switch on the unit to CCU.
Once connection is made correctly and power is supplied to
the unit, the CAMERA POWER indicator on the unit and the
POWER indicator on the CCU light in green.
Using the cable clamp belt
When a cable clamp belt (supplied) to the unit, an optical fiber
cable can be fastened to the front panel of the unit.
1
Insert the belt bracket into the upper loop of the cable
clamp belt and secure the cable clamp belt to the
camera, using the two supplied screws (+B3
Belt
bracket
(supplied)
2
1 Release the buckle, 2 bundle the cable with the
belt, 3 then lock the buckle again.
18
Installation and Connections
×
8).
Cable clamp attachment
screw holes
Two screws
(supplied)
Cable clamp belt (supplied)
1
3
Adjust the length by pulling down the end of the belt.
3
Optical fiber
cable
2