Table of Contents
Advertisement
l CAM-SUB(R) DC OUT connector
To supply power to the camera (10.5 to 17 V DC, 5.5 A
In 3D mode, connect to. the DC IN connector of a camera used
as a sub camera (right).
1) The power capacity to be supplied is limited. For details see "Notes
on Power Supplied from This Unit" (page 14).
m AUDIO IN 1 connector (XLR 3-pin) and select switches
Connect a channel 1 audio signal and set the switch according
to the connected source device.
Audio input select switch
Set to the appropriate position according to the equipment
connected to the AUDIO IN 1 connector.
MIC: When an external microphone is connected
LINE: When a line-level (0 dBu) signal source is connected
Microphone power switches
When a microphone is connected to the corresponding AUDIO
IN 1 connector, set whether or not to supply a power to the
microphone.
OFF: Not to supply a power
+48V: To supply a power of +48 V
(No function has been assigned to the uppermost position. No
power is supplied to the microphone.)
Note
To supply a power of +12 V, consult your Sony representative.
n AUDIO IN 2 connector (XLR 3-pin) and select switch
Connect a channel 2 audio signal and set the switch according
to the connected source device.
Audio input select switch
Set to the appropriate position according to the equipment
connected to the AUDIO IN 2 connector.
MIC: When an external microphone is connected
AES/EBU: When a digital audio signal is connected (The
signal must be in synchronization with the camera output).
LINE: When a line-level (0 dBu) signal source is connected
Microphone power switches
When a microphone is connected to the corresponding AUDIO
IN 2 connector, set whether or not to supply a power to the
microphone.
OFF: Not to supply a power
+48V: To supply a power of +48 V
(No function has been assigned to the uppermost position. No
power is supplied to the microphone.)
Note
To supply a power of +12 V, consult your Sony representative.
o DC IN (DC power supply input) connector (XLR 4-pin)
For connection to an AC-DN10 AC Adaptor, etc. to supply
power (10.5 to 17 V DC) to the unit.
p DC OUT (DC power supply output) 4A max connector
(4-pin)
To supply power to an external device such as a lens (10.5 to
2)
17 V DC, max. 4 A
). The output current depends on the
device to be used.
2) The power capacity to be supplied is limited. For details, see "Notes
on Power Supplied from This Unit" (page 14).
q AUX connector (12-pin)
For the future use.
r CRANE connector (12-pin)
1)
max.).
For external interface, such as viewfinder and trunk signal.
s TRACKER connector (10-pin)
For communication a camera operator and tracker, and
transmission of Intercom 1 and 2. An up tally signal and
program audio signal are also output.
t RET CTRL (return control) connector (6-pin)
For connection to a CAC-6 Return Video Selector.
u DC OUT (DC power supply output) 0.5A max connector
(4-pin)
To supply power to a script light of a BKP-7911 Script Holder
(10.5 to 17 V DC, max. 0.5A
3) The power capacity to be supplied is limited. For details, see "Notes
on Power Supplied from This Unit" (page 14).
3)
).
Overview
13
Advertisement
Table of Contents
