Establish A Static Channel Connection - Black Box COMPACT T1 Quick Start Manual

Quick Start
Configuration

Establish a Static Channel Connection

Use the following commands to establish a static channel connection.
Command
set {slot:port:channel} type
{voice|data}
set {slot:port:channel} signal
{ls|gs|emw|emdw|emicpd|dpt}
connect {slot:port}
{slot:port}
Set Up a ISDN BRI Service
Use the following commands to set up a ISDN BRI Service. See the set (bri) command
for details.
Command
set {slot:port} up
set {slot} mode
{lt3ds0|lt4to1tdm|nt3ds0}
set {slot:port} crv {1-768}
set {slot:port} threshold
{day|hour} {es|ses}
set {slot} pmsync
{adit|switch}
set {slot:port} autoactivate
{on|off}
26
Description
Set the channel type for the channel you want
to map. See set (ds0) command for details.
Set the channel signaling option. See set (ds0)
command for details.
Connect the channels. See the connect (card-
trunk) (card-trunk) command for details.
Description
Put the ISDN line In-Service.
Set the ISDN mode.
Set the Call Reference Value. Note: value
must be the same as the Access Navigator.
Set the threshold for the IDSN lines.
Set the source for performance monitoring
synchronization.
Only used in 4 to 1 mode. Establishes the D
channel when the FDL link can not be used.
Compact T1 - Release 6.1