Configuring Switched Pdus Over Ethernet - Avaya Pod Fx Troubleshooting Manual

No. Task
13 Attach all cables.
14 Confirm PDU operation.
15 Confirm equipment
operation.
16 Return faulty PDU.
Related links
Troubleshooting hardware issues

Configuring switched PDUs over Ethernet

Configuring switched PDUs over a Console connection
Configuring switched PDUs over Ethernet
About this task
This procedure provides the information necessary to configure a switched PDU using the internal
Avaya Pod Fx network. PDU configuration is required after installing a new PDU. See
switched PDUs over Console Connection
PDU using a DB9 connection.
October 2017
Description
page 58 for configuration
procedures.
Attach equipment cables
to the PDU in the same
location they were
attached in the faulty PDU.
See the Customer
Lifecycle Workbook for
cable locations.
Inspect all equipment to
ensure it is now displaying
two green power supply
LEDs for each piece of
equipment.
Confirm that all equipment
is operational, including
the replacement PDU. The
PDU LED display should
be showing the same
current level as the
corresponding paired
PDU.
Installer or technician must
return the faulty PDU to
Avaya using standard
equipment return
procedures.
on page 45
on page 55
on page 58
on page 58 for the procedure to configure a switched
Troubleshooting the Avaya Pod Fx
Comments on this document? infodev@avaya.com
Checklist for replacing a Power Distribution Unit
Notes
™
Configuring
55