Chapter 3: Configuring Monitoring And Alerts; Configuring Nimble Cs1000 Monitoring - Avaya Pod Fx Troubleshooting Manual

Chapter 3: Configuring monitoring and
This section contains information about the configuration of monitoring and alerts for the elements of
the Avaya Pod Fx.
Related links

Configuring Nimble CS1000 monitoring

Nimble CS1000 and VPFM alarms
Configuring EMC VNXe3200 monitoring and EMC Secure Remote Support
Configuring EMC VNX5300 monitoring and EMC Secure Remote Support
Configuring alarm notifications
Configuring Nimble CS1000 monitoring
About this task
Use the following procedure to configure diagnostic monitoring on the Nimble CS1000.
Procedure
1. Open a new browser window or tab.
2. Enter the management IP address of the storage array.
3. Log in to the management interface with the Administrator credentials.
4. Select Administration > Alerts and Monitoring > Diagnostics from the menu.
5. Select Allow Nimble Storage Support to collect analytics data automatically from the
array.
6. Select Enable Secure Tunnel.
7. Click Test Diagnostics for Nimble Analytics Settings.
A test is performed on the diagnostic settings. A checkmark should appear beside every item
in the test window. If the test fails, ensure that your firewall is allowing traffic from the
Management IP and Controller Support IP addresses. Run the test once again. Troubleshoot
and run the test until all items in the test pass.
8. Click Send Diagnostics for Nimble Analytics.
October 2017
alerts
on page 12
on page 13
on page 17
Troubleshooting the Avaya Pod Fx
Comments on this document? infodev@avaya.com
on page 14
on page 15
™
12