Table of Contents
Advertisement
The solar panel is detected but does not have enough voltage to charge the
battery. The DC-Load is ON and there is no load, or it is very low to be detected.
The solar panel is unavailable (e.g. at night or disconnected). The DC-Load port
is ON and the load is drawing current from the battery.
The solar panel is unavailable (e.g. at night or disconnected). The DC-Load is
ON and there is no load, or it is very low to be detected.
The solar panel is unavailable (e.g. at night or disconnected). The battery
is connected. The DC-Load port is OFF.
Display Symbols
These symbols indicate the battery type. Note: Some units may have symbols
showing lo
The related symbol shows the charging stage at the moment (Bulk, Absorption, or
Floating). They are mutually exclusive (only one at a time). They may take up to 10
sec to be updated to a new different stage. In both Unit Setting and Setting
Display modes having either Lithium or Program selected, the "Bulk" symbol goes
on to indicate the Absorption voltage setting (see note
In Unit Setting and Setting Display
The display is showing 1 of the 3 DC-Load ON or OFF timers values, as per the
symbol being shown, which flashes periodically with 1, 2, or 3 pulses pattern to
indicate that the value corresponds to the timer 1, 2, or 3 respectively.
(mutually
exclusive)
These alarm clock symbols are not showed when they are disabled.
Note
In any condition, the '24V' symbol indicates that a 24V battery system has been
detected and is in use. Otherwise, It remains OFF indicating a 12V battery system.
In Normal Operating Mode: The display is showing the net battery discharging
current in Amps. In other words, the charging current from the solar panel is less
than the discharging current by the DC loads on terminals 5-6, so the battery is
discharging supplying the difference of current and showing it on the display.
display is showing the DC-Load port Disconnect /Reconnect Voltage respectively.
The display shows time/Net battery charging or discharging current/
Battery voltage/Timer setting/Error code, e.g. 12:04/21.2/12.3/C01 or
C00/E02 respectively.
This symbol indicates the afternoon time ('Post Meridiem').
The display is showing the net battery charging/discharging current in Amps.
The display is showing the battery voltage in Volts.
Error is detected and the display is showing its code in the E01-E05 range.
'
' '
Li
ro instead of looded
: these symbols never appear in Normal perating
Page
'
'
Lithium
: Solid/Flashing means that the
of 21
' modes
rogram respectively.
)
:
ode.
Advertisement
Table of Contents
