Related Manuals for Nature Power 38330
Summary of Contents for Nature Power 38330
- Page 1 3000W Pure Sine Inverter Charger White (Used for black or dark grey background color) (38330) Owner’s Manual SINGLE COLOR (Used for background colors other than Black or White)
- Page 2 Important Please be sure to read and save the entire manual before using your Nature Power Inverter. Misuse may result in damage to the unit and/or cause harm or serious injury. Read manual in its entirety before using the unit and save manual for future reference.
-
Page 3: Important Safety Information
IMPORTANT SAFETY INFORMATION This section contains important safety information for the unit. Each time, before using the unit, READ ALL instructions and cautionary markings on or provided with the unit, and all appropriate sections of this guide. The unit contains no user-serviceable parts. See Warranty section for how to handle product issues. DANGER: Fire and/or Chemical Burn Hazard. -
Page 4: Table Of Contents
Table of Contents INTRODUCTION .................... 5 PRODUCT DESCRIPTION ................ 5 INSTALLATION .................... 6 UNIT OPERATION ................... 1 0 TROUBLESHOOTING .................. 1 3 ... -
Page 5: Introduction
1. INTRODUCTION Thank you for purchasing the Nature Power 3000W Pure Sine Inverter-Charger. With our state of the art, easy to use design, this product will offer you reliable service by providing AC power for your home, cabin, boat, RV or Trailer and recharge your battery automatically when utility AC is available. -
Page 6: Installation
AC Output Neutral Bonding: Each AC source must have its neutral conductor bonded to ground. When the Nature Power Inverter-Charger is running in Battery-Inverter mode, the internal neutral-to-ground bonding system is enabled. The unit will act as an AC source and will automatically connect the AC Output Neutral (N1 &... - Page 7 Typical Wiring block diagram of the Inverter-Charger DC Fuse or Over Inverter Current Protective AC Output Disconnect Inverter-Charger Device Battery Panel Switch (IC1230150) Bank (AC Output) Input: Main AC AC Source Input Panel (AC Input) 12V Battery Bank: • The use of a deep cycle battery is highly recommended for power inverter application. •...
- Page 8 Important: Follow the electrical and/or building code when you connect the unit to any AC source. Inverter AC Output Panel (wire size and breaker size): • #10 AWG wire is required for all AC Output connections based on the full 30A pass-through rating between the unit and the AC Inverter AC Panel.
- Page 9 located at the left hand side of the AC compartment is intended for use with AC Input ground wire. The right hand side ground bus is intended for use with AC Output ground wire. • Remove the left hand side AC knockout. Install the strain-relief clamp in the AC knockout. •...
-
Page 10: Unit Operation
• The unit is successfully installed and functioning properly. 4. UNIT OPERATION Auto Backup Mode (Factory Default Setting) The unit is fully automatic. When utility power is available, the unit is running in AC bypass mode. AC output is supplied from the utility. The internal AC charger is ON and will automatically top up the battery bank that is connected to the unit. - Page 11 Button Function Turns LCD display On/Off. Press and hold for 2 seconds to turn display On/Off. Display shows unit model number and revision. Nature 38330 e.g. Power REV 1.1 Enter Save the selected setting or go to the next stage...
- Page 12 Optional Battery Temperature Sensor Feature: Optional Battery Temperature Sensor Nature Power Part Number #BTS-10K is highly recommended to be used with the charger to protect your battery and provide better charging voltage accuracy. The battery temperature sensor senses the battery temperature and makes adjustments to the charging voltage.
-
Page 13: Feature Setting
Estimated Run Times Following run times are estimates for reference, based on using different battery bank sizes. Actual run times may vary. Estimate run time on different 12V Battery Bank Size AC Load 60AH 120AH 180AH 240AH 300AH 50 W 11 hrs. -
Page 14: Troubleshooting
6. TROUBLESHOOTING To troubleshoot the unit, please note the error code displayed on the main unit and review “Understanding the Error Codes” in section 4. Problem Symptom Solution Condition: Inverter setting is set to Off, AC source is available No AC Output. Unit is turned Off Turn unit ON by following the instruction in Charging LED... -
Page 15: Specifications
7. SPECIFICATIONS Note: Specifications are subject to change without notice. Nature Power 3000W Pure Sine Specification Inverter-Charger Inverter AC Output Power 3000W AC Output Current AC Surge Power (Peak) 6000W (5 seconds) AC Output Voltage/Frequency 120 VAC / 60 Hz AC Output Waveform True Sinewave (<5% THD) -
Page 16: Warranty
The limited warranty program is the only one that applies to this unit, and it sets forth all the responsibilities of Nature Power. There is no other warranty, other than those described herein. Any implied warranty of merchantability of fitness for a particular purpose on this unit is limited in duration to the duration of this warranty.